D2394 (version 17(2022))

1.1 These test methods cover procedures for measuring the performance of finish flooring under the following service loadings and conditions:

 

Section

Loading Tests

 

 Concentrated Loading

 7

 Floor Surface Indentation from Small Area Loads

12

 Falling-Ball Indentation

18

 Rolling Load

23

Mechanical Tests

 

 Abrasion Resistance

28

 Coefficient of Friction

33

Moisture Tests

 

 Surface Wetting

38

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.